裝載機電子秤使用注意事項？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：965次
裝載機永保機械電子秤數據穩定、制造工藝先進、檢驗手段齊全計量準確，保證稱重過程中能稱量出最高精度的物品，得到了廣大用戶的歡迎和好評。那么在使用過程中應該注意什么呢？
一、裝載機電子秤開機前應先啟動裝載機,提升動臂8次左右做預熱處理,以便使液壓油及壓力傳感器預熱到正常用工作溫度，減少油溫不穩對稱重精度的影響。
Boot loader scales preceded Boot Loader enhance instability affecting oil boom around 8 times do preheating so that the hydraulic oil pressure sensor and warm to normal operating temperature by reducing weighing precision.
二、在稱重過程中,應避免裝載機行駛,稱重結束后可任意行駛速度不限.如在稱重中行駛,則車速應控制在5km/h以下,但準確度會降低0.5%；提升動臂經過位置傳感器時,提升速度盡量均勻。
In the weighing process, should avoid driving loaders, weighed not limited to any conclusion as in weighing the traveling speed driving, the speed should be controlled at 5km / h or less, but accuracy will be reduced by 0.5%;. Enhance the action after the arm position sensor, increase speed as even as possible.
三、裝載機在稱重時應盡量選擇在較平坦的地面上進行提升稱重。
Loader should try to choose weighed on relatively flat ground level to enhance weighed.
四、當完成此次稱重后,料斗應回落到最低位置,以備下次鏟料稱重。
Upon completion of the weighing, the hopper should fall to the lowest position to prepare for the next shovel weighed.
