裝載機應該加多少傳動油？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：2642次
1.裝載機加傳動油加到加油孔里面有10CM油就足夠了。
1.Shandong loader plus drive oil added to the gas hole inside the 10CM oil is enough.
2.裝載機變速油很簡單，首先你先用鏟車挖個坑，把車在坑上面變速箱對準坑。然后直接拆油底殼下面的那個最大的油管。
2.Shandong loader gear oil is very simple, first you shovel to dig a hole, put the car in the pit above the gearbox alignment hole. Then directly remove the oil pan under the largest tubing.
3.然后把變速箱箱體上有兩個的把下面的那個開關打開，一直加到下面的開關開始漏油，那么你在繼續加10秒左右就可以了（有的只有一個開關，同樣也是加到漏油然后繼續加10多秒再關閉)，一般都是一桶半多一點。
3.Then the gearbox has two to open at the bottom of the switch, has been added to the following switch began to leak, then you continue to add about 10 seconds can (some only a switch, is also added to the oil spill and continue to add more than 10 seconds and then close), the general is a bucket of half a point.
