裝載機燃油消耗如何判斷？
[ 發布日期：2023-01-07 15:10:28 ] 來源:永保機械 瀏覽：927次
裝載機http://m.ts0775.cn/發動機正常工作時，燃油消耗量遠遠超過正常標準。
When the loader engine work, the fuel consumption far exceeds the normal standards.
裝載機http://m.ts0775.cn/在未超載的情況下，先檢查底盤傳動系和行走系是否有異常。如無異常，可檢查供油系統是否供油過量。在上述檢查都無異常時，應拆下噴油器，測量氣缸壓力，所測氣缸壓力不得低于3.92×103kPa(為使發動機運轉穩定，各缸壓力差應不超過8%)，如測量值低于此值即為發動機內部故障。
Loader in the absence of overload, check the chassis and running gear drivetrain is abnormal. Without exception, you can check whether the excess oil supply system. When these checks are without exception, should be removed injectors,cylinder pressure measurement, the measured cylinder pressure of not less than 3.92 × 103kPa (for the stable operation of the engine, each cylinder pressure difference should not exceed 8%), as measured Below this value is the internal engine failure.
